Micro-surfacing equipment meters emulsion, aggregate, water, filler and additives, mixes them in a pugmill and places the material through a spreader box.
Micro-surfacing units prepare and place chemically stabilized cold surfacing material. They are associated with wheel-path rut filling, surface texture restoration, skid improvement and preventive maintenance on structurally sound pavements.
The machine must hold the ratio of emulsion, aggregate, filler and water as paver speed changes. Independent feed systems and a consistent spreader box help control thickness and joint texture; material recipe and pavement preparation determine whether the treatment performs.
Aggregate bin and water tank capacities, filler capacity, metering accuracy, pugmill size, spreader-box width, chassis or trailer option, control system and available operator documentation. The emulsion grade and mix design should be supplied or agreed before quotation.
These points help engineering compare models, avoid unsuitable oversized or undersized options, and prepare the correct technical and commercial document set.
Start with the application and material, not the model number. Compare cold mix surface treatment capacity basis, working width or output, chassis or skid option, control arrangement, maintenance access and transport dimensions against the project datasheet.
Include the main task, material type, expected duty cycle, site access, utility conditions, target timing, destination port, required certificates and any local approval requirement. Photographs or tender clauses help engineering give a specific answer.
Final capacities and dimensions, configuration options, shipping mode, document set, commissioning guidance, operator-training scope and wear-parts plan should be confirmed in the written proposal rather than assumed from generic marketing copy.
This equipment reference summarizes public catalogue information and engineering selection points. Model capacity, dimensions, certification and commercial terms must be taken from the final datasheet, technical proposal or signed agreement.
Send the application, the material and the output you need. You will get a configuration proposal with capacity, chassis options and delivery window — not a catalogue page.