Self-propelled chip spreader with hydraulic-mechanical control and full operator visibility.

Our SA3C1 stone chip spreader is used for the even spreading of stone chips on asphalt-covered road under black road surfacing construction in addition to spreading aggregate chips on clay-bound macadam.
With the stone chip spreader, two hydraulic cylinders are installed under moving stripper plates equipped at both sides of the back hopper and can be controlled to discharge stone chips from moving stripper plates respectively into two troughs of rubber-belt chip conveyors. This prevents any material pile-up in the trough and at the same time, a sufficient supply for distributing stone chips can be assured. The stone chip spreader is designed with hydraulic hooking at the end of the back hopper to enable a large dump truck (referring to "Jiefang" 5t dump truck) to be hooked and pulled. Thanks to this design, continuous operations of spreading stone chips can be achieved while dumping stone chips into the back hopper. In addition, the hopper size allows for chippings size up to 40mm. Our stone chip spreader can be conveniently transferred to various construction worksites for pavement construction.
Working Principle The basic working principle of the stone chip spreader starts with stone chips being unloaded from dumper to the back hopper and distributed to the front hopper by rubber belt conveyer. Once the hoppers are full-loaded, the stone chip spreader drives on an asphalt-sprayed road while pulling the discharging roller to evenly spread quantitative stone chips on asphalt layers from the front hopper. Stone chips in the back hopper are continuously distributed to the front one while spreading stone chips.
Specifications are model-specific and can be varied for a project. Confirm the final datasheet with engineering before ordering.
| Specification | Value |
|---|---|
| Chippings Width | ≤40mm |
| Back Hopper Capacity | 2m3 |
| Rubber Belt Conveyer Capacity | 50 -100 m3/h |
| Engine Power | 70kW |
| Working Speed (when engine frequency is 1600r/min) | First gear: 1.52km/h |
| Working Speed (when engine frequency is 1600r/min) | Second gear: 2.87km/h |
| Working Speed (when engine frequency is 1600r/min) | Third gear: 4.97km/h |
| Working Speed (when engine frequency is 1600r/min) | Forth gear: 9.39km/h |
| Working Speed (when engine frequency is 1600r/min) | Fifth gear: 11.49km/h |
| Working Speed (when engine frequency is 1600r/min) | Reverse gear: 1.35km/h |
| Maximum Traveling Speed | 20km/h |
| Minimum Turning Radius (inside) | 8.4m |
| Wheelbase | 3400mm |
| Front Track | 1927mm |
| Rear Track | 1820mm |
| Minimum Ground Clearance | Front Wheel: 260mm |
| Minimum Ground Clearance | Rear Wheel: 180mm |
| Tire Type | 1100-20 14R |
| Dimension (L*W*H) | 7100mm x 3688mm x 2420mm |
| Weight | About 6200kg |
Dimensions and capacities are model-specific and may be varied for a project. Confirm the final datasheet with engineering before ordering.

Cement, lime and fly-ash spreader for cold recycling and roadbed stabilization.
LMT5250FSBDetails →
Gravity-fed aggregate spreader for seal coats and surface treatment, up to 3.5 m working width.
SS-3100 / SS-3500Details →
Intelligent tri-axle sealer that sprays binder and aggregate in one pass under closed-loop control.
LMT5312TFCDetails →Send the application, the material and the output you need. You will get a configuration proposal with capacity, chassis options and delivery window — not a catalogue page.